If you have a fire or water emergency, please call us now at (866) 838-5200

To have the optimal experience while using this site, you will need to update your browser. You may want to try one of the following alternatives:

Fire & Water - Cleanup & Restoration


Main Water Supply Line Pipe Burst in Mt. Laurel, NJ

Main Water supply line burst inside Basement in Mt. Laurel NJ

This result caused about 6 inches of water throughout basement. Extraction, portable pumps, Air Movers and dehumidifiers were required to dry out the structure.  

The following method can be used to determine the amount of dehumidification, either conventional refrigerant, LGR refrigerant or desiccant, to dry a structure after water damage. These guidelines are based on the IICRC’s S500 standard version 3. 1. Determine the volume of the area that is water damaged and can be isolated from other open areas. Length X Width X Height = Cubic feet of space where dehumidification is required 2. Determine the Class of the Water Damage. Class 1 (least amount of water, absorption and evaporation) Water damage restoration projects that affect only a part of a room or area; or larger areas containing materials that have absorbed minimal moisture. Little or no wet carpet and/or cushion are present. Class 2 (large amount of water, absorption and evaporation) Water damage restoration projects that affect at least an entire room of carpet and cushion (pad). Water has wicked up walls less than 24 inches. There is moisture remaining in structural materials (e.g., plywood particle board, structural wood, VCT, concrete and substructure soil). Class 3 (greatest amount of water, absorption and evaporation) Restoration projects in which water has wicked up walls greater that 24 inches, or it enters from overhead affecting the ceiling , walls, insulation, carpet, cushion, and subfloor. The entire area is saturated. Class 4 (specialty drying situations) These consist of wet materials with very low permeance/porosity (e.g., hardwood, plaster, brick, concrete, light wet concrete and stone).Typically, there are deep pockets of saturation, which require very low relative and specific humidity for drying.

Project was a success and completed in fast time frame and prevented microbial growth. Customer was satisfied and provided referral for neighbor.